0
点赞
收藏
分享

微信扫一扫

华为业务口堆叠配置

cwq聖泉寒江2020 2022-04-29 阅读 35
网络

华为业务口堆叠
在这里插入图片描述

一、配置集群连接方式、集群ID及集群优先级

配置SwitchA的集群连接方式为业务口集群,集群优先级为100,集群ID为1(缺省为1无需配置)。

[SwitchA] set css mode lpu

[SwitchA] set css id 1

[SwitchA] set css priority 100

配置SwitchB的集群连接方式为业务口集群,集群ID为2,集群优先级为10。

[SwitchB] set css mode lpu

[SwitchB] set css id 2
[SwitchB] set css priority 10
二、配置逻辑集群端口

配置SwitchA的业务口XGE1/0/1~XGE1/0/2为集群物理成员端口并加入集群端口1,XGE2/0/1~XGE2/0/2为集群物理成员端口并加入集群端口2。

[SwitchA] interface css-port 1[SwitchA-css-port1] port interface xgigabitethernet 1/0/1 to xgigabitethernet 1/0/2 enable[SwitchA-css-port1] quit[SwitchA] interface css-port 2[SwitchA-css-port2] port interface xgigabitethernet 2/0/1 to xgigabitethernet 2/0/2 enable[SwitchA-css-port2] quit

配置SwitchB的业务口XGE1/0/1~XGE1/0/2为集群物理成员端口并加入集群端口1,XGE2/0/1~XGE2/0/2为集群物理成员端口并加入集群端口2。

[SwitchB] interface css-port 1[SwitchB-css-port1] port interface xgigabitethernet 1/0/1 to xgigabitethernet 1/0/2 enable[SwitchB-css-port1] quit[SwitchB] interface css-port 2[SwitchB-css-port2] port interface xgigabitethernet 2/0/1 to xgigabitethernet 2/0/2 enable[SwitchB-css-port2] quit
三、使能集群功能

使能SwitchA的集群功能并重新启动SwitchA。

[SwitchA] css enableWarning: The CSS configuration will take effect only after the system is rebooted. The next CSS mode is LPU. Reboot now? [Y/N]:y

使能SwitchB的集群功能并重新启动SwitchB。

[SwitchB] css enableWarning: The CSS configuration will take effect only after the system is rebooted. The next CSS mode is LPU. Reboot now? [Y/N]:y

举报

相关推荐

0 条评论